Table of Contents
Advertisement
4.
Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
5.
Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC.
6.
The first and second clamps must be positioned and secured diagonally prior to mounting
the rest of the clamps. Tighten the clamp's screw using an electric screwdriver by pressing
the white plastic cap onto the back of the panel. The illustration below shows that all clamps
are properly mounted.
Note:
Note:
The maximum thickness of your panel's mounting wall should be 10 mm for secure
The system also has one additional full-size Mini PCIe and one half-size Mini PCIe slot
panel mount.
that use the mSATA and LPC interface respectively.
Chapter 6 Mounting Options
Chapter 6
White plastic cap
Mounting clamp
Slit for mounting the clamp
30
www.dfi.com
Advertisement
Table of Contents
