Table of Contents
Advertisement
Super IO Configuration
Sets the parameters of serial port 1 to serial port 6.
Restore AC Power Loss
Set the AC power loss to power-on or power-off. When set to power-off, the system's
status will be powered off after an AC power loss event. When it is set to power-on,
the system's status will be powered on after an AC power loss event.
WatchDog Timer Unit
Enable or disable the watchdog function and select the timer unit for the WatchDog
timer in seconds or minutes. A counter will appear if you select to enable the WDT.
Input any value between 1 to 255 in the "SuperIO WatchDog Timer" field.
Chapter 7 BIOS Setup
Chapter 7
Serial Port 1-6 Configuration
Enable or disable each COM port.
Change Settings
Select the IO and IRQ address for each COM port.
COM Driver Mode
Set the serial communication mode for each COM port. This option is only available
for COM Port 1 to 4.
33
www.dfi.com
Advertisement
Table of Contents
