Setting Hi/Lo Limits - Keysight U1701B User's And Service Manual

2 Features and Functions

Setting HI/LO limits

To set the HIGH and LOW limits for compare mode, refer to the following
procedures:
1 Press and hold SET key for more than 1 s to enable the HI/LO limit setting
2 The secondary display will flash L01 and the primary display will indicate the
3 SET: Select next compare setting. Press this key momentarily to cycle through
4 Press and hold the SET key for more than 1 second to exit the HI/LO limit
36
mode.
limit value. The following keys will be used for this setting mode:
a (Left) or (Right): select which digit to be adjusted.
b (Up) or (Down): to Increase or decrease the current digit value.
c HI/LO: Select High or Low limit to be set.
d SAVE: Press this key for more than 1 second to store the setting value into
the memory. The beeper will beep twice, meaning the selected value has
been stored. If the current setting does not meet the rule that the HI limit
must be equal or greater than the LO limit, the beeper will beep three
times.
#01 to #25 then return to #01 setting according to Hi/LO limit.
setting mode.
Keysight U1701B User's and Service Guide