Counting Application Supervisor Menu - Avery Weigh-Tronix ZM303 User Instructions

7.3 Counting application supervisor menu

Figure 7.3
Appears only if Preset
Tare is enabled
Super
Setpnt Tare
Edit
Tare 1
Edit Print
Port 1
Annun Out1
Key
Off On
in
value
Units Select
Stop ID
Follow these steps to set the items in the Supervisor menu.
The Setpnt, Tare and bAttErY submenus in
General Weighing application supervisor menu on page
on those submenus. The unique submenus to this application are described below.
The cnt Acc submenu is the same described in the Accum submenu in the
Accumulator application. Refer to step
ZM303 Indicator User Instructions
shows the Supervisor menu when you are in the Counting application:
Count Battery
Enable
Off On
Mode Prt Tot
Off On
Bulk Dribble
Print
Port 1 Port 2 USB
Tare 10
Reset
Port 2 USB No
Out2 Out3
Key Key
in in
value value
Tare Zero
Setup Under
Figure 7.3 Supervisor menu for the Count application
7.3
Tmout
1-3600
minutes
Tot Fmt Clr Tot
Off On
Enter Print format #
for Total operation
Reset
No Yes
Yes
In1 In2
None
Sample F1 Target
Over Accu PrntHld
Figure 7.3
3 on page 56.

Counting application supervisor menu

SELECT =
TARE =
PRINT =
UNITS =
ZERO =
F1 = Escape or
Bold boxes and text
denote defaults.
In3 Mode
Act Abv
Print
Start
User
are the same as described in
48. Go there for information
Act Bel
59