Using Entered Tare; Using Preset Tare - Avery Weigh-Tronix ZM303 User Instructions

Indicator applications

Using Entered Tare

To perform a net weighment using entered tare, the following steps describe a typical
operation:
1.
2.
3.
4.
5.

Using Preset Tare

Preset tares are entered in a password protected menu. There can be up to 10 tares
numbered 1-10. To perform a net weighment using one of the preset tares, follow these
steps:
1.
2.
3.
4.
5.
Tare is removed automatically if Auto Tare Clear is enabled. To remove the tare
weight manually, select a preset tare register that has a value of 0 for the tare.
If the active unit of measure is lb-oz then tare weights must be entered in the oz
equivalent. To enter 2 lb 4.5 oz you would need to enter 36.5 oz (2 lb = 32 oz plus the
4.5)
18
With no weight on the scale, if the display does not read 0 press ZERO ...
0 is displayed and the center-of-zero annunciator lights.
Key in the tare value of the container or box that will be used to hold the
material that requires a net weight value, and press TARE ...
Tare weight is displayed as a negative value and the NET annunciator
lights.
Place the container or box and material to be weighed on the scale ...
Net weight of material is displayed.
If repeated weighments use the same tared item, you do not need to establish
a new tare value as described in step 2.
To remove the tare weight from the scale, enter 0, then press TARE ...
The tare is cleared and the scale is in gross weigh mode.
With no weight on the scale, if the display does not read 0 press ZERO ...
0 is displayed and the center-of-zero annunciator lights.
Press TARE ...
Tare number entry screen appears.
Key in the preset tare number and press ZERO ...
Tare weight is displayed as a negative value and the NET annunciator
lights.
Place container or box and material to be weighed on the scale ...
Net weight of material is displayed.
Repeat step 4 until you are finished using that tare weight.
ZM303 Indicator User Instructions