Using Setpoints - Avery Weigh-Tronix ZM303 User Instructions

3.1.4 Using setpoints

Setpoints are values (weight) at which outputs are triggered automatically. Outputs can
control relays connected to valves, lights, other machinery, etc. Setpoint outputs can
be configured in the setpoint menu shown in
See the note below for an overview of how setpoints function.
Default Setpoint operation
Outputs must be enabled for setpoints to operate. See the Service Manual
Below Configured Value:
Outputs are OFF
Annunciators are OFF
Above Configured Value:
Outputs are ON
Annunciators are ON
The setpoint outputs and setpoint annunciators logic state can be inverted
from their default settings to be ON when below and OFF when above the
configured value. Refer to details in the password protected menu settings in
the section titled
The annunciator and output will turn on when weight goes above the setpoint for that
output and will remain on until the weight falls below the setpoint.
Follow these steps to configure the outputs:
1.
2.
3.
4a.
ZM303 Indicator User Instructions
Press SETUP
Setpnt
out1
Key
setpoint
Figure 3.1 Setpoint menu
Setpoint on page
With the indicator powered up, press SETUP ...
SEtPnt is displayed. Refer to the Setpoint menu, shown in
while following the steps below
Press SELECT ...
out1 is displayed.
Press SELECT ...
Current value is displayed with the last digit flashing.
Key in a value and press ZERO to accept the value ...
out1 is displayed.
3.1
Figure 3.1.
out3
out2
Key Key
in in in
setpoint setpoint
49.
General weighing application
:
Figure 3.1
19