Peak Hold Application; Select Key Default Function; Special Key Functions; Peak Hold Operation - Avery Weigh-Tronix ZM303 User Instructions

Indicator applications

3.6 Peak hold application

This section applies if your indicator has the Peak Hold application active.

3.6.1 SELECT key default function

In the Peak Hold application you can view the gross, max and min display values by
repeatedly pressing SELECT.

3.6.2 Special key functions

The following key has an extra function in this application:
F1

3.6.3 Peak hold operation

Only the highest weight applied to the scale is displayed when the peak weight value
is selected to be displayed. Minimum weight is designated by a pair of green circle
annunciators. Maximum weight is designated by a different pair of green circle
annunciators. See
With the Peak application active, follow these steps to perform and view peak
weighments.
1.
2.
3.
4.
32
F1 resets the min and max peak weights to the current gross weight.
Figure 3.3.
These two
annunciators light
for minimum weight
Figure 3.3 Min/Max annunciators
Repeatedly press SELECT until the two green circle annunciators on the right
light up. See Figure 3.3. This means you are now viewing the peak or maximum
weight.
With no weight on the scale, press ZERO, if necessary press F1 to reset any
previous peak value on the display.
Place weight on the scale and then remove it ...
The display will show the peak weight recorded during the weighment.
To reset the peak, press F1 ...
The minimum and maximums are reset to the current gross weight.
lb
These two
annunciators light
for maximum weight
ZM303 Indicator User Instructions