Bulk Sampling - Avery Weigh-Tronix ZM303 User Instructions

Indicator applications
4b.
Minimum sample weight is the gross zero band value. The initial sample count is 5
pieces. The maximum number of pieces that can be sampled is 100,000.
5.
6.

3.3.5 Bulk sampling

With the counting application and the bulk sampling method active, follow these steps
to count.
1.
2.
3.
4a.
OR
4b.
5.
24
Enter a new sample size and press ZERO ...
Add is displayed. Count the number of sample items onto the scale and
when ready press SAMPLE or F1 ...
buSY is briefly displayed, followed by one of two possible outcomes:
a. If the sample met the minimum sample requirements and the weight is
stable, the display will show the correct number of parts on the scale
and COUNT is lit.
b If the sample size was not large enough or if the weight was unstable,
Abort is briefly displayed and the display returns to gross weighing
mode. Repeat steps
Place the parts on the scale to be counted. To accumulate the count and
number of transactions, press PRINT while in count mode.
If enabled, press and hold PRINT for three seconds to print and/or clear the
active count total. These functions are enabled or disabled in a password
protected menu.
Press ZERO to zero the scale, if necessary.
Use a tare method to tare a container, if necessary.
17.
Press SAMPLE or F1 ...
ZEroing is briefly displayed. This shows the indicator is zeroing itself. A
numeric value (XX) is then displayed. This is the current sample size.
Accept the current sample size by pressing ZERO
Enter a new sample size and press ZERO ...
Add is then displayed.
Place the correct number of samples on the scale all at the same time.
buSY is briefly displayed, followed by one of two possible outcomes:
a. If the sample met the minimum sample requirements and the weight is
stable, the display will show the correct number of parts on the scale
and COUNT is lit.
3 through 5 using a larger sample size.
SeeNet weighing on page
ZM303 Indicator User Instructions