Installation Of The Firewire Driver For The Variocam ® Hr Head - InfraTec VarioCAM User Manual

Hide thumbs Also See for VarioCAM:

Table of Contents

Should the thermographic system VarioCAM

the infrared camera is not compulsory. However, it is recommended to always operate the thermographic

system via a separate DC power supply unit. The 6-pin FireWire (IEEE 1394) cable (see Fig. 11, FireWire

(IEEE 1394) cable, 6-pin, page 17) makes the hardware connection between the PCI-IEEE 1394 interface

of the PC and the VarioCAM

Should the thermographic system VarioCAM

power supply, the manufacturer will not accept any liability for the appropriate operation of the

thermographic system.

8.3

Installation of the FireWire Driver for the VarioCAM

For installing the device driver "vc_hires23", the access rights of the user group "Administrators" are

definitely required. After successful installation, the programme IRBIS

with the access rights of the user group "Main users".

VarioCAM

hr head and the PC/notebook are connected with the help of the included FireWire

(IEEE1394) cable. Then the PC/notebook and the thermographic system are to be powered on.

Fig. 28 Device manager – "Imaging device"

Should you already have installed the infrared camera VarioCAM

of the file "VC2.inf", the camera will register within the device manager under "IEEE 1394 bus host

controller". In this case, the current driver "vc_hires23.inf" must be allocated by function "Update

User Manual for the Thermographic System VarioCAM

8 Hardware and Software Installation for VarioCAM® hr head*

hr had be operated by a PC, an additional power supply for

hr.

hr head be operated by a PC without any separate

online/process can be used

Fig. 29 Automatic hardware detection

hr head into your control PC by means

hr head

User Manual

Table of Contents