InfraTec VarioCAM User Manual page 22

When connecting the thermographic camera with the PC/notebook for the first time, automatic hardware
recognition will be activated. Further steps for installing the FireWire (IEEE1394) driver for the VarioCAM
head are described in Chapter 8.3, Installation of the FireWire Driver for the VarioCAM
Connection with a power supply unit*
Fig. 16 Power supply unit with plug
Fig. 17 LEMO adapter
Connection without a power supply unit
18
User Manual for the Thermographic System VarioCAM
When operating the VarioCAM
(FireWire connection without any power supply), the
thermographic system is to be connected via a power
supply unit by means of the 14-pin LEMO plug.
As an alternative, power can also be supplied via the 6-
pin LEMO socket on the right at the rear of the
VarioCAM ® hr head or of the Breakout Box. For this
purpose, the LEMO adapter is connected to the power
supply unit.
© InfraTec GmbH 2015
®
hr head
7. Starting up
®
®
hr head, page 6.
® hr head on a notebook
User Manual
hr