Motorola MVX1000 User Manual page 56

3 - 24 MVX1000 In-Car Digital Video System User Guide
Table 3-8 describes the optional indications displayed on the Sensors Tab screen.
Your system may include other sensors not specified
NOTE
configured to trigger recording, while others only provide status of the relevant condition during
active recording. Recording can be stopped manually.
For example, brake signal does not trigger recording, but is saved in the metadata as part of the
recorded incident, including pre-event buffer.
For more information on the sensors installed in your vehicle, consult your agency system
administration.
Your system may be pre-configured to trigger recording when GPS speed had exceeded a pre
NOTE
defined threshold. Recording can be stopped manually.
For example, when the self seed of a vehicle is higher than pre-configured threshold, the
MVX1000 starts recording.
Optional Indications Displayed on the Sensors Tab Screen
Table 3-8
No. Indication
1 Brake
2 Siren
3 Lights
6 Crash Sensor
7 GPIO
The brake sensor is activated whenever the vehicle brakes are used.
The output signal of the brake is recorded as an evidence in the
MVX1000 System.
The output signal of the siren sensor triggers the MVX1000 System to
save and record pre and post event siren evidence.
The output signal of the emergency lightbar sensor triggers the
MVX1000 System to save and record pre and post event evidence.
The crash sensor is activated if the vehicle is involved in a collision. The
output signal of the sensor triggers the MVX1000 System to save and
record pre and post crash evidence. The crash sensor is manually reset
using a button at the top of the sensor.
The General Purpose Input Output (GPIO) indication is displayed if the
current port is not connected to a sensor.
inTable 3-8. Some sensors may be
Description