Setting The Transmission Mode When Using The Ams Function - Yaesu FTM-7250DR Operating Manual

Setting the transmission mode when using the AMS function

The AMS function will automatically set the receiver to the mode of the received signal,
but the transmission mode may be fixed regardless of the received mode.
1. Press and hold the [ GM ( AMS )] key.
2. Rotate the DIAL knob to select the
the desired transmission mode as
follows.
AUTO (" " blinks: 0.5 sec of, 0.5 sec off)
Automatically selects one of the two
communication modes according to
the received signal.
TXMANUAL ("
Automatically selects one of the two
communication modes according to
the received signal. Briefly pressing
PTT on the microphone switches be-
tween digital mode and analog mode.
TX FMFIX (" " blinks: 0.5 sec on, 0.5 sec off)
Automatically selects one of the two
communication modes according to
the received signal. Always switch-
es to FM mode for transmission.
TX DIGTL (" " blinks: 0.5 sec on, 0.5 sec off)
Automatically selects one of the two
communication modes according to
the received signal. Always switch-
es to DN mode for transmission.
TX VWFIX (" " blinks: 0.5 sec on, 0.5 sec off)
Note: When the Setup Menu item "DIG VW 13" is set to "ON" (factory default is "OFF"),
the "TX VWFIX" may be selected.
Automatically selects one of the two
communication modes according to
the received signal. Always switch-
es to VW mode for transmission.
3. Press the [ GM ( AMS )] key to save the new setting and exit to normal operation.
" blinks: 1 sec on, 0.5 sec off)
Basic Operation
: DN mode
: VW mode
: FM mode
Blinks: 0.5 sec on
0.5 sec off
: DN mode
: FM mode
Blinks: 1 sec on
0.5 sec off
FM mode
Blinks: 0.5 sec on
0.5 sec off
DN mode
Blinks: 0.5 sec on
0.5 sec off
VW mode
Blinks: 0.5 sec on
0.5 sec off
15