Memory Operation; Memory Storage - Yaesu FTM-7250DR Operating Manual

Memory Operation

The FTM-7250DR provides a wide variety of memory system resources. These include:
r 199 "basic" memory channels, numbered "1" through "199".
r 6 "Home" channels. A Home Channel can be set and recalled on each frequency band.
r 10 sets of band-edge memories, also known as "Programmable Memory Scan"
channels, labeled "L0/U0" through "L9/U9".
Each memory may be appended with an alphanumeric label of up to 8 characters, for
quick channel recognition.

Memory Storage

1. In the VFO mode, select the desired frequency and the communication mode to be
registered to a memory channel.
2. Press and hold the [ V/M ( MW )] key.
A memory number will appear in the
bottom right corner of the display.
Note: If the channel number is blinking, there currently is no data stored on that chan-
nel; if the channel number is not blinking, that channel is currently "occupied" by
other frequency data.
3. Rotate the DIAL knob to select the desired mem-
ory into which you wish to store the frequency.
Note: While operating in the Memory Storage mode, the keypad of the MH-48A6JA
Microphone may be used to enter the memory channel number directly.
To do this, enter the desired Channel Number on the keypad. Refer to the "For
example" of the "Memory Recall from the Microphone Keypad" on page 27.
4. Press the [ V/M ( MW )] key.
The memory tag input screen will be displayed
on the display.
If not entering a nametag à proceed to step 8.
5. Rotate the DIAL knob to select the first digit of
the desired label.
6. Press the [ V/M ( MW )] key to move to the next
character.
To make a correction, press the [ BAND ( SQL )] key to move the cursor to the left, then
re-enter the correct letter, number, or symbol.
7. Repeat steps 5 through 6 to program the re-main-
ing letters, numbers, or symbols of the desired
label. A total of 8 characters may be used in the
creation of a label.
26