Installation; Connecting The Microphone; Connecting The Antenna; Mobile Installation - Yaesu FTM-7250DR Operating Manual

Installation

Connecting the Microphone

Connect the supplied MH-48A6JA micro-
phone to the FTM-7250DR.
Plug the microphone connector into the MIC
jack on the front panel until it clicks.
Note: When disconnecting the microphone,
pull the cable while pressing the con-
nector latch.

Connecting the Antenna

Connect the coaxial cable to the body.
Plug the coaxial cable jack into the ANT ter-
minal on the rear panel of the body, then ro-
tate and tighten it.

Mobile Installation

The FTM-7250DR must only be
installed in vehicles having a 13.8
Volt negative ground electrical
system. Mount the transceiver
where the display, controls, and
microphone are easily accessi-
ble, using the supplied mounting
bracket.
The transceiver may be installed
in almost any location, but should
not be positioned near a heating
vent nor anywhere where it might
interfere with driving (either visual-
ly or mechanically).
Make sure to provide plenty of space on all sides of the transceiver so that air can flow
freely around the radio's case. Refer to the diagrams showing proper installation proce-
dures.
6
Microphone
Connector
Coaxial cable plug
MIC
ABC DEF
1 2 3 A
GHI JKL MNO
4 5 6 B
PQRS TUV WXYZ
7 8 9 C
0 D
DTMF MICROPHONE
MH-48