Repeater Operation; Checking The Repeater Uplink (Input) Frequency; Tone Calling (1750 Hz) - Yaesu FTM-7250DR Operating Manual

Advanced Operation

Repeater Operation

The FTM-7250DR includes the ARS (Automatic Repeater Shift) function, which permits
communication through repeaters automatically, by simply setting the receiver to the re-
peater frequency.
1. Tune to the repeater frequency.
2. Press the PTT switch to transmit.
During transmission, radio waves having an 100.0 Hz* tone signal are emitted on the
frequency offset from the receive frequency by 0.6 MHz* (144 MHz) or 5 MHz (430
MHz)*.
*: Depends on the transceiver version.
Note: From the Setup Menu, you can change the repeater setting.
RPT ARS 35
RPT FREQ 36 à Allows changing the repeater shift frequency offset.
RPT SFT 37

Checking the Repeater Uplink (Input) Frequency

It is often helpful to be able to check the uplink (input) frequency of a repeater, to see if
the calling station is within direct ("Simplex") range.
Note: For details, refer to the Advanced Manual (download from the Yaesu website).

Tone Calling (1750 Hz)

If your transceiver is FTM-7250DE (European version), press and hold in the program key
[ P4 ] of the microphone (MH-48) to generates a 1750 Hz burst tone to access the European
repeater. The transmitter will automatically be activated, and a 1750 Hz audio tone will
be superimposed on the carrier. Once access to the repeater has been gained, you may
release the [ P4 ] key, and use the PTT switch for activating the transmitter thereafter.
24
à Deactivates the ARS function.
à Allows setting the repeater shift direction.