Unpacking And Setting-Up The Printer; Connecting The Device; Switching On The Device - CAB Hermes+ Operator's Manual

2 Installation
2.2

Unpacking and Setting-up the Printer

 Lift the printer out of the box.
 Check printer for damage which may have occurred during transport.
 Remove foam transportation safeguards near the printhead.
 Check delivery for completeness.
Contents of delivery:
• Printer
• Power cable
• USB cable
• Operator's Manual
• DVD with label software, Windows driver and documentation
Notice!
i
Please keep the original packaging in case the printer must be returned.
Attention!
!
The device and printing materials will be damaged by moisture and wetness.
 Set up printers only in dry locations protected from splash water.
2.3

Connecting the Device

The standard available interfaces and connectors are shown in figure 6.
2.3.1 Connecting to the Power Supply
The printer is equipped with a wide area power unit. The device can be operated with a supply voltage of
230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1. Check that the device is switched off.
2. Plug the power cable into the power connection socket (24 / Fig. 6).
3. Plug the power cable into a grounded socket.
2.3.2 Connecting to a Computer or Computer Network
Attention!
!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the printer are grounded.
 Connect the printer to a computer or network by a suitable cable.
For details of the I/O interface, the connector emergency stop and the connector central valve  Interface
Description.
For details of the configuration of the other interfaces  Configuration Manual.
2.4

Switching on the Device

When all connections have been made:
 Switch the printer on at the power switch (24 / Fig. 6).
The printer performs a system test, and then shows the system status Ready in the display.
If an error occurs during the system test, the symbol and type of error are displayed.
9