Cut-Out Mark Dimensions - CAB MACH 4.3S/200B Operator's Manual

8 Media
8.4

Cut-out Mark Dimensions

for marginal cut-out marks
minimum liner thickness 0,06 mm
Figure 26 Cut-out mark dimensions
Dim. Designation
A Label distance
N Width of cut-out mark
P Height of cut-out mark
X Distance mark - middle of paper track
for gap sensor recognition
for reflective sensor recognition
Sensor recognized virtual label front edge
Y1
Y2
Distance recognized front edge - actual label front edge
Z1
Z2
 Adjust software settings
Backside of the material must be sufficiently reflective.
1)
Table 11 Cut-out mark dimensions
Marginal cut-out
Figure 27 Samples for cut-out marks
Labels with cut-out marks
with reflective sensor recognition
with gap sensor recognition
with reflective sensor recognition
with gap sensor recognition using transparent labels
Long hole cut-out
Endless material with cut-out marks
1)
Rectangular cut-out Circular cut-out
Not recommended !
27
Dim. in mm
> 2
> 5
2 - 10
-10 or 0
-56 up to +10
Front edge cut-out
Rear edge cut-out
P up to A
0 up to A-P
Cut-out
between the labels
Not recommended !