Use Quick Connect Via Front Rs232 Port; Use Quick Connect Via Front Usb Port - GE L60 Instructions Manual

CHAPTER 3: INSTALLATION
• View the last recorded oscillography record
• View the L60 protection summary
• View all of the L60 metering values
• View the status of all L60 inputs and outputs
• Generate a service report

3.8.2 Use Quick Connect via front RS232 port

This feature applies to the enhanced and standard front panels.
To connect to the UR from a computer using a serial cable:
1. Connect an RS232 serial cable to the computer and the front panel RS232 port.
2. Start the EnerVista UR Setup software, or in EnerVista Launchpad select the UR device to start the software.
3. Click the Quick Connect button. The window opens.
4. Select the serial Interface and the communications port (COM Port) from the drop-down lists, then click Connect. The
COM Port is that of the computer.
5. The EnerVista software creates a site named "Quick Connect" with a corresponding device also named "Quick
Connect" and displays them in the Online Window. Expand the sections to view data directly from the UR device. Use
the Device Setup button to change the site name.
Each time that the EnerVista UR Setup software is initialized, click the Quick Connect button to establish direct
communications to the L60. This ensures that configuration of the EnerVista UR Setup software matches the L60 model
number.

3.8.3 Use Quick Connect via front USB port

This feature applies to the graphical front panel.
To connect to the UR from a computer using a USB cable:
1. Connect the cable to the computer and the front panel USB port (square connector).
2. Start the EnerVista UR Setup software, or in EnerVista Launchpad select the UR device to start the software.
3. Click the Quick Connect button to open the window.
4. Select the USB Interface and the "GE Virtual Serial Port" driver from the drop-down list, then click Connect. If the GE
driver does not display, it means that the USB cable was connected on Windows 10 when upgrading the UR software.
You need to re-install the EnerVista software with the USB cable disconnected.
5. The EnerVista software creates a site named "Quick Connect" with a corresponding device also named "Quick
Connect" and displays them in the Online Window. Expand the sections to view data directly from the UR device. Use
the Device Setup button to change the site name.
L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL
Figure 3-70: Quick Connect window to access a device
CONNECT TO THE L60
3
3-67