Oscillography; Data Logger - GE L60 Instructions Manual

CHAPTER 6: ACTUAL VALUES

6.5.3 Oscillography

6.5.3.1 Enhanced and standard front panels
ACTUAL VALUES  RECORDS  OSCILLOGRAPHY
 OSCILLOGRAPHY

This menu allows the user to view the number of triggers involved and number of oscillography traces available. The cycles
per record value is calculated to account for the fixed amount of data storage for oscillography. See the Oscillography
section of chapter 5 for details.
A trigger can be forced here at any time by setting "Yes" to the FORCE TRIGGER? command. See the
menu for information on clearing the oscillography records.
RECORDS

6.5.4 Data logger

ACTUAL VALUES  RECORDS  DATA LOGGER
 DATA LOGGER

The represents the time at which the oldest available samples were taken. It is static until the log gets
OLDEST SAMPLE TIME
full, at which time it starts counting at the defined sampling rate.
The represents the time the most recent samples were taken. It counts up at the defined sampling
NEWEST SAMPLE TIME
rate. If the data logger channels are defined, then both values are static.
See the
COMMANDS  CLEAR RECORDS
L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL
Figure 6-7: Event record
FORCE TRIGGER?

No
NUMBER OF TRIGGERS:

0
AVAILABLE RECORDS:

0
CYCLES PER RECORD:

0
LAST CLEARED DATE:

2000/07/14 15:40:16
OLDEST SAMPLE TIME:

2000/01/14 13:45:51
NEWEST SAMPLE TIME:

2000/01/14 15:21:19
menu for clearing data logger records.
Range: No, Yes
COMMANDS  CLEAR
RECORDS
6
6-27