EFD ULTIMUS V User Manual page 21

Setting a New Password
• Highlight Set PASSWORD and press the Enter key.
• When the Password screen appears, enter the new
password and press the Enter key.
• When the Please Confirm Operation screen appears,
press F1 (Yes) to save the new password or F3 (No)
to keep the original password
Clearing a Password
• Pressing and holding the Enter and 1 keys while the Ultimus V is powering up will reset the security
password.
• The Please Confirm Operation screen will appear. Pressing the YES function key will reset the
password to '0000' (all zeros). Pressing the NO function key will allow the Ultimus V to continue to
power up without resetting the password.
Alarm Options Screen
• The Alarm Input Signal is the signal that is sensed on the Alarm Input pins of the digital I/O connector.
The dispenser will not allow any dispense cycles to occur when this signal is active. The Alarm Input
Signal is enabled when a check mark is shown in the box next to Enable Input Alarm Signal.
• The Alarm Input Signal can trigger the Alarm Output Signal on the Digital I/O connector. A check mark
in the box next to Enable Input Alarm Output Signal
indicates the Alarm Output Signal is enabled for
Input Alarm Signals.
• The Alarm Input Signal can be latched. When an
Alarm Input occurs and it is latched, the user must
reset the Input Alarm before the dispense cycle can
resume.
To reset the Input Alarm, view the main screen and
use the Up/Down (8/2) and Left/Right (4/6) keys to
select the Input Alarm. Pressing the F2 (Reset) key
will reset the Input Alarm. A check mark in the box
next to Enable Input Alarm Latching indicates that
the Alarm Input Latch is enabled.
www.efd-inc.com info@efd-inc.com
.
USA & Canada 800.556.3484 Europe +44 (0) 1582 666334 Asia & China: +86 (21) 3866 9006
dispensing systems are available worldwide .
Sales and service of EFD ®
Basic Menu
Operation
21