Procedure Before Operation - Mitsubishi QD60P8-G User Manual

4 SETUP AND PROCEDURE BEFORE OPERATION

4.2 Procedure before Operation

Module mounting
Mount the QD60P8-G in the specified slot.
Wiring
Wire the QD60P8-G.
Intelligent function module switch setting
Perform settings using the GX Developer
(Refer to Section 4.5).
4
Use the GX Configurator-CT?
Initial setting
Create a sequence program for writing
initial values (Refer to Chapter 7).
Program and debugging
Create and check the sequence program
(Refer to Chapter 7).
4 - 2
The figure below shows the steps that should be followed before starting the QD60P8-
G operation.
Start
No
Operation
Yes
Initial setting
Perform the initial setting using the
GX Configurator-CT (Refer to Section 6.4).
Perform auto refresh setting?
Auto refresh setting
Perform the auto refresh setting using the
GX Configurator-CT (Refer to Section 6.5).
Monitor/Test
Perform the monitor or test using the
GX Configurator-CT (Refer to Section 6.6).
MELSEC-Q
No
Yes
4 - 2