Mitsubishi QD60P8-G User Manual page 112

9 TROUBLESHOOTING
Item
INPUT V Input voltage selection
PLS EDGE Pulse edge selection
RNG LIN Linear counter or Ring counter selection
FIL 4-1 Input filter setting (CH1 to CH4)
FIL 8-5 Input filter setting (CH5 to CH8)
NOP
9 - 4
(3) Confirmation of Module's detailed information
Check the module information, the LED statuses, and the statuses of setting with
the intelligent function module from "H/W Information" of Module's detailed
information that can be displayed on the system monitor of GX Developer
(Version 7.17T or later).
[Setting procedure]
Chose [Diagnostics]
choose "Module's Detailed Information"
[H/W LED Information]
H/W LED information displays the following information.
Item
RUN "RUN" LED of QD60P8-G
ERR "ERR." LED of QD60P8-G
[H/W SW Information]
The setting status of the intelligent function module switches are displayed.
Signal name
[System monitor]
Signal name
Corresponding switch
Switch 1
Lower 8 bits
Switch 2
Upper 8 bits
Switch 3
Switch 4
Switch 5
MELSEC-Q
"QD60P8-G module" and
H/W Information .
Value
0: LED OFF
1: LED ON
Value
For details, refer to "Section 4.5
Switch setting for intelligent
function module".
9 - 4