Graco Therm-O-Flow 200 Instructions - Parts Manual page 106

Appendix A - ADM
Gateway 1 and 2
If the Therm-O-Flow system has a communication gate-
way module (CGM) installed, an additional "Gateway"
chapter containing 1 or 2 pages will be available in the
setup screens. These pages enable the user to set the
CGM IP or device address, configure the field bus proto-
col selections, and enable the user to view the mapping
information programmed into the CGM module. The
screens shown below illustrate the 2 pages provided if
an Ethernet I/P CGM module is installed. Refer to man-
ual 3A5186 for information on mapping and the screens
available for the other field bus options.
106 334130L