Repair
Repair
Replace Wipers
1. To replace a worn or damaged wiper (V) raise the
ram plate up out of the drum. Perform steps 1
through 7 of Change Drums, page 36. See wiper kit
manual for instructions about replacing the wipers.
V
F
. 25: Replace Wiper
IG
Replace Platen RTD
Reference Electrical Schematics, page 59, for wiring
connections.
1. If the material drum has already been removed from
the supply unit, go to step 2. If you need to remove
the material drum, see Change Drums, page 36.
46
2. Make sure the ram plate is down and the ram hand
valve is in the OFF position.
To reduce the risk of injury or damage to equipment,
make sure the main power switch is off before con-
tinuing with this procedure.
3. Turn the main power switch off.
4. Remove the pump cover.
F
. 26: Pump Covers and Platen RTD
IG
5. Remove the platen RTD (605) from the platen.
CC
CB
334130L