Switching The Server On And Off - Fujitsu PRIMERGY 400 Operating Manual

Switching the server on and off

ON/OFF switch
switches the server on or to ready-to-operate.
The ON/OFF switch and the main switch do not disconnect the server from the line
i
voltage. To disconnect the line voltage completely, remove the power plug from the
socket.
System indicators
Power-on indicator
glows orange or does not light (P270), when the server is ready-to-operate.
lights green when the server is switched on.
Drive active
lights green when an SCSI drive is being accessed.
Drive indicators
Hard disk drive active
Lights when the drive in this slot is being accessed.
Drive error (only in conjunction with disk array controller)
Lights orange when the drive is defective and needs replacing, or if the slot is not correctly
inserted.
Blinks orange when a rebuild is carried out by the DAC after changing a hard disk drive.
Indicator CD-ROM drive active
The indicator lights up when the CD-ROM drive is accessed.
Indicator floppy disk drive active
The indicator lights up when the floppy disk drive is being accessed.
Indicator chipcard reader active (optional)
lights up when the chipcard reader is being accessed.
Switching the server on and off
If after switching on the server there is nothing but flickering stripes on the screen, switch
!
the server off immediately (see
monitor screen").
The ON/OFF switch and the main switch do not disconnect the server from the line
voltage. To disconnect the line voltage completely, remove the power plug from the
socket.
Because only the servers with a standard power supply are equipped with an ON/OFF switch, the
procedure for switching the servers on or off differs.
Server with modular power supply
Servers with a modular power supply are switched on or off by pressing the ON/OFF switch.
A26361-K632-Z100-1-7619
Preparation for use and operation
"Troubleshooting and tips" - "Flickering stripes on the
31