Table of Contents
Advertisement
System expansions for tower server
Removing a board
Ê
Remove the left-hand side cover (see "
Ê
Remove the lines connected to the board.
1
2
Ê
Press on the clip in the direction of the arrow (1) and remove it (2).
Ê
Pull the board out of the slot (3).
1
2
Ê
Insert the rear slot cover plate into the empty slot (1). Make sure that the rear slot cover plate is
positioned in the groove (a).
Ê
Insert the clips for securing the rear slot cover plate as shown (2). Ensure that the clip engages
in the casing.
Ê
Replace the left-hand side cover (see "
Power supply module
The servers with a modular hot-plug power supply can be equipped with one or two power supply
modules. With two power supply modules the servers are equipped with a redundant power supply.
If one module fails, the respective other module ensures unimpaired further operation. The defective
module can be replaced during operation.
60
Opening the
server").
1
3
2
1
1
2
2
a
Assembling the
Power supply module
server").
A26361-K632-Z100-1-7619
Advertisement
Table of Contents
