Reference Manual
00809-0100-4811, Rev AB
July 2003
VOLUME
CONFIGURATION
Transmitter Variables
1, 1, 1, 1
HART Comm
Volume Units
1, 3, 2, 2
HART Comm
Tank Type
1, 4, 3, 1
HART Comm
Tank Dimensions
1, 4, 3, 2
HART Comm
Strapping Table
1, 4, 3, 4
HART Comm
Select the Volume option in order to configure the transmitter for volume
measurements.
Choose one of the following units:
•
Gallons
•
Liters
•
Imperial Gallons
•
Cubic Meters
•
Barrels
•
Cubic Yards
•
Cubic Feet
•
Cubic Inch
Choose a standard tank shape, or select the strapping option. Standard
shapes are: Vertical Cylinder, Horizontal Cylinder, Vertical Bullet, Horizontal
Bullet or Sphere. (If Primary Variable is Level choose None for Tank Type).
If your tank does not correspond to any of the above tank shapes, select Strap
Table.
If a standard tank type was chosen, enter the diameter and height of the tank.
See "Volume Configuration" on page 4-5 for information on how to specify
tank dimensions.
If tank type Strapping Table was chosen, enter how many entries you will use
and the actual level and volume points. You can enter from 2 to 10 points. The
strapping points must be entered such that the first point corresponds to the
lowest level, and the last point corresponds to the topmost level of the tank.
Rosemount 3300 Series
4-13