Safety Messages; Appendix B Safety Messages - Emerson Rosemount 3300 Series Reference Manual

Guided wave radar level and interface transmitters
Hide thumbs Also See for Rosemount 3300 Series:
Table of Contents

Advertisement

Reference Manual
00809-0100-4811, Rev AA
July 2003
Appendix B

SAFETY MESSAGES

www.rosemount.com
Hazardous Approvals
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-1
European Atex Directive Information . . . . . . . . . . . . . . . . page B-2
Hazardous Locations Certifications . . . . . . . . . . . . . . . . . page B-4
Approval Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-6
Procedures and instructions in this section may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol (
refer to the following safety messages before performing an operation
preceded by this symbol.
Explosions could result in death or serious injury:
Verify that the operating environment of the gauge is consistent with the appropriate
hazardous locations certifications.
Before connecting a HART-based communicator in an explosive atmosphere, make
sure the instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Do not remove the gauge cover in explosive atmospheres when the circuit is alive.
Failure to follow safe installation and servicing guidelines could result in death or
serious injury:
Make sure the transmitter is installed by qualified personnel and in accordance with
applicable code of practice.
Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
Do not perform any service other than those contained in this manual unless you are
qualified.
High voltage that may be present on leads could cause electrical shock:
Avoid contact with leads and terminals.
Make sure the main power to the Radar Transmitter is off and the lines to any other
external power source are disconnected or not powered while wiring
the gauge.
Rosemount 3300 Series
). Please

Advertisement

Table of Contents
loading

Table of Contents