Rosemount 3300 Series
ERROR MESSAGES
Figure 5-2. Presentation of error
messages
ALARM AND WRITE
PROTECTION
Figure 5-3. Alarm and Write
Protection switches.
5-2
The display can alos be used for presentation of software errors. The upper
row shows error codes and the lower row shows 'ERROR'.
The following errors can be displayed:
Code
Error
CNFIG
Invalid Configuration
00001
Ram Failure
00002
ROM Checksum
00006
Waveform Acquisition Failure
00007
EEprom Factory Checksum
00010
Software Error
00013
Probe Failure
See also "Errors." on page 6-20.
When mounting the Integral Display panel it is important that the Alarm and
Write Protection switches on the transmitter mother board are correctly set.
Make sure that the Alarm switch is in the HIGH position and the Write
Protection switch is in the OFF position, see Figure 5-3. See also Section 3:
Before You Install for more information.
Once the mother board positions are set, then the display positions become
the master.
Reference Manual
00809-0100-4811, Rev AB
Error code
"ERROR"
July 2003
Motherboard