Disassembling Handles Adjusting System On Chest Press - Technogym MA05 Service Maintenance Manual

ELEMENT LINE: Service & Maintenance Manual - rev. 1.2
5.10. DISASSEMBLING HANDLES ADJUSTING SYSTEM ON
CHEST PRESS
Figure 5.10-1
Figure 5.10-2
Figure 5.10-3
1. Back off the screw (a) using a 6-mm hex
wrench.
2. Back off the screws (b) using a 6-mm hex
wrench.
3. Remove the handle assembly from the
machine lever.
4. Remove the selector plate (c).
Take care during reassembly procedure
to replace the plate "c" in the right way
as shown in the figure to side.
Continued on next page
Page 5.15
→