Total Trunk: Service & Maintenance Manual - rev. 1.5
7. DISASSEMBLY OF COMPONENTS
7.1.
DISASSEMBLING THE ELECTRONICS BOX
Figure 7.1-1
Figure 7.1-2
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Back off the 2 screws a using a medium
Phillips screwdriver.
3. Remove the top plate from the box.
To disassemble the components:
Power inlet block b:
1. Disconnect the cables;
2. Remove it from the side plate of the
electronics box.
Power supply for component power supply box
c:
1. Disconnect the cables;
2. Remove it by detaching the Velcro.
PC power supply d:
1. Disconnect the cables;
2. Remove it by detaching the Velcro.
Component power supply box e:
1. Disconnect the cables;
2. Remove it by detaching the Velcro.
Component interface box f :
1. Disconnect the cables;
2. Remove it by detaching the Velcro.
Pagina 7.1