ROTEX XT: Service & Maintenance Manual - rev. 1.0
7. DISASSEMBLY OF COMPONENTS
7.1. DISASSEMBLING THE DISPLAY
Figure 7.1-1
Figure 7.1-2
1. Turn off the machine and unplug the mains
lead from the wall output.
2. Unscrew the 6 self-tapping screws a which
fix the DISPLAY, using a large Phillips
screwdriver.
Support the DISPLAY before removing
the last screw.
The 2 lower screws hold the lexan
instruction panel in place.
3. Open the DISPLAY.
To remove the DISPLAY:
1. Disconnect connectors b.
2. Remove the DISPLAY.
To reassemble the DISPLAY, carry out the
above steps in reverse order.
Page 7.1