Disassembling The Rollers Adjusting System - Technogym KINESIS STATION Service Maintenance Manual

5.5.2. D
ISASSEMBLING THE ROLLERS ADJUSTING SYSTEM
Figure 5.5-4
Figure 5.5-5
Figure 5.5-6
Page 5.22
KINESIS STATION: Service & Maintenance manual - rev. 4.2
Carry out the procedure detailed at paragraph:
5.5.1. "Disassembling the knee upholstery rest
group".
1. Back off the screw (a) using a medium
Phillips screwdriver.
2. Back off the 2 screws (b) using a 4mm
hexagonal wrench.
3. Remove the guard (c).
4. Back off the 2 screws (d) using a 4mm
hexagonal wrench.
5. Remove the guard (e).
6. Back off the screw (f) using a 5mm
hexagonal wrench locking down, on the
opposite side, the pin (g) using a 6mm
hexagonal wrench, as shown in the figure.
Continued on the following page...