ELEMENT LINE: Service & Maintenance Manual - rev. 1.2
Figure 5.7-4
Figure 5.7-5
Figure 5.7-6
2. Back off the screw (f), using a 8-mm hex
wrench.
3. Remove the plastic stop (g).
4. Release the tension on the weight stack cable
by clamping the first plate as shown in the
figure.
5. Lift the selector pin using a pair of pliers and
turn the cam toward the back of the machine,
disengaging the cable from it.
6. Remove the pin (h) and its spring, pulling it
out from the bottom of the machine.
To reassemble the unlocking lever, carry out the
above steps in reverse order.
Page 5.11