Chapter 5: Configure System For Use; Enable Administrative Communication; Communications Settings - Dell DD9500 Manual

Hide thumbs Also See for DD9500:

Table of Contents

Topics:

•

•

Accepting the End User License Agreement

•

Run the configuration wizard

•

Configuring additional system parameters

•

Configure HA for new installations

Enable administrative communication

For HA pairs, administrative communication must be enabled on both nodes.

The administrative interfaces are located on the management module on the rear of the chassis. These interfaces are for

management network traffic only. Do not use these interfaces for data traffic.

1. Connect an administrative console to the serial port on the back panel of the system.

NOTE:

You must have 115200 baud rate for the DD9500 system to work properly; 9600 baud rate will not work for the

DD9500 system.

Launch a terminal emulation program from your computer and configure the following communication settings:

Table 27. Communications settings

Setting

Baud rate

Data bits

Stop bits

Parity

Flow control

Emulation

3. Select Enter on your keyboard to activate the console.

NOTE:

If you do not see the prompt on your terminal to log in, then complete Step 4.

4. In the front of theDD9500 system, press the power button to power on the system. Check that the front blue power LED

(with the circle with a dot) also turns on.

Configure System for Use

Value

115200

None

VT-100

Table of Contents