DR4300 Circular Chart Recorder
2.3.4 Mounting on a 2-inch pipe
Refer to Figure 2-5 and follow the procedure in Table 2-4 to mount your recorder on a 2-inch pipe.
Step
1
Using the eight plastite screws supplied with the pipe mounting bracket kit, attach the two
mounting brackets (flat side against the case) to the back of the recorder. Refer to Figure 2-5
for location.
2
Position the recorder with brackets on the 2-inch pipe.
3
Install the U-bolts around the pipe and through the bracket holes. Secure with lockwashers
and hex nuts provided.
20
Table 2-4 Pipe Mounting Procedure
Hex Nut
Figure 2-5 Pipe Mounting Brackets
DR4300 Circular Chart Recorder Product Manual
Action
Pipe Mounting
Washer
Bracket
Rear
of
Case
U-bolt
Plastite
Screw
24224
3/00