Promag TR510E Manual page 6

daily bell schedule of up to 32 different bell times can be defined in Everyday
mode. Seven bell schedule tables can be defined from Sunday to Saturday in
Week mode, and each table also has up to 32 different bell times can be
defined.
Relay connector is located under the metal back plate. Figure above shows
connector position and pin assignment. Both Normally Closed (N.C.) and
Normally Opened (N.O.) contacts are provided.
Locking event selection (IN or OUT)
By default, the TR510E allows the User to choose the desired event (IN or
OUT) prior to reading the ID-card. There is a setting provided that allows event
selection to be fixed either at IN or OUT (see Section 4). This arrangement may
be desirable in case several TR510Es are used, with some machines installed
at the entrance and serving for registering IN events, and some machines
installed at the exit and serving for OUT registration only. Fixing the event
prevents the User from choosing an alternative event at the moment of reading
ID-card.
There is another setting provided that allows event selection automatically to
be set either at IN or OUT depends on a pre-scheduled event table. The pre-
scheduled event table features up to 32 entries. There are two fields of each
pre-scheduled event table entry: 'time' field and corresponding event mode
'IN/OUT' field. When time up to the scheduled time, the TR510E will
automatically switch event selection at IN or OUT by your setting in pre-
scheduled event table.
TR510E User's Manual
6
N.C.
C
N.O.