Promag TR510E Manual page 42

Parity: None, Stop bits: 1, Flow control: None
The HyperTerminal's main window will appear
o
•
Choose TransferSend file from the Main menu- the Send file
dialog will appear
•
In the Send file dialog, select the file you want to download and
choose Xmodem protocol from the Protocol drop-down box
•
The Xmodem file send for dialog will be displayed
•
Press and hold the IN button, then power up the TR510E while still
keeping the IN button pressed. The unit will generate a long beep and
display "FLLD" (FLASH Load):
•
When receiving the file, the TR510E will blink its IN LED (the LED is
on while the TR510E is receiving or expecting to receive a block of
data from the PC; the LED is off while the TR510E is programming
the data received into its internal FLASH memory)
•
Once the downloading is finished, the TR510E will execute one long
beep and display "DONE":
•
You may start using the newly downloaded firmware after switching
the unit off and back on again.
Note: When turn power-up TR510E at first time after downloaded firmware
it will take 25 seconds to set default values for all internal registers, in the
meanwhile LED will display "INIT":
A number of errors may occur during the download. Errors are displayed in
the "ERRx" format, where x is the error number, for example:
In addition, the TR510E generates a beep pattern comprised of a long beep
followed by one or several short beeps. The number of beeps corresponds to
the error number.
All possible download-related error codes are listed in the table below:
TR510E User's Manual
42