Promag TR510E Manual page 10

'J' 4AH
'K' 4BH
'N' 4EH
'G' 47H
'W 57H
'
'E' 45H
'M' 4DH
'L' 4CH
'O' 4FH
'Z' 5AH
Note 1. D-command never returns error message even if the data supplied in the
command packet is incorrect. Invalid command packet makes it impossible to determine
which terminal is being addressed and, therefore, which one should reply with an error code.
Self-test takes place on the next power-up, not immediately.
Note 2.
Terminal will deny this command when all data have not sent out completely yet
in real-time data transference mode.
The TR510E have 3 group registers. Group-1 is for accessing registers for
"LED mode", "bell duration", "32 entries of bell table times field (Everyday
mode)", "32 entries of bell table enable/disable field (Everyday mode)", "event
lock mode", "Relay function", "event table times field (32 entries)", "event table
enable/disable field (32 entries)", and "bell table mode (Everyday or Week)",
"Daylight Saving Time", "Enable/Disable Daylight Saving Time function", "Door
lock duration", "Prefix to match", "From Character", "Number of characters".
Group-2 is for accessing registers of "7x32 entries for bell table times field
(Week mode, from Sunday to Saturday)". Group-3 is for accessing registers of
"7x32 entries of bell table enable/disable field (Week mode, from Sunday to
Saturday)".
TR510E User's Manual
table)
Set group-3 registers (see group-3
table)
Get group-3 registers (see group-3
table)
Get number of records
Get specified record
Get total capacity of database (in
records)
Initialize the database
Prepare for database recovery
Enable/Disable
transmission function
Get real-time data transmission
function status
Perform self-test**
real-time data
10
+ +
+ + +
+ +
+ + + +
+
+ +
+
Note 2
+
+