Appendix A. Possible Errors; Appendix B. Interface Connector Pin Assignment - Promag TR510E Manual

Appendix A. Possible Errors

This Section lists all possible error messages that may be generated during the
TR510E's normal operation. The table below does not apply to the Test and
FMM modes of the TR510E (see Sections 5 and 6 respectively for complete
details on errors generated in these modes).
LED

Appendix B. Interface connector pin assignment

Error
ID-card read error. Read the card again
Read
error
The database is full and new record cannot be
Database
added.
full
Incorrect setting value. Reinitialize the TR510E by
Error 4
issuing the R-command
The database is corrupted. First, try to power the
Error 5
TR510E off and back on again. If this doesn't
help, initialize the database using the E-command
or recover the database using the M-command
Time/date is not set. Use the S-command to
Error 6
correct the problem or reinitialize the TR510E
using the R-command
#1
#2
#3
#4
#5
#6
#7
#8
Description/ Remedy
TX+
TX -
RX+
No connection
No connection
RX-
No connection
No connection
46