Promag TR510E Manual page 34

don't forget to enable Daylight Saving Time function by setting group-1 register
87H as 01, then the function will work immediately. If set the start-date same as
end-date, the Daylight Saving Time function will be automatically disabled by
TR510 itself but content of register 87H will not be changed. If set the date of
start-date behind end-date TR510E will consider the start-date as next year
date.
Note: February 29 will be denied to set as start-date or end-date by TR510E.
Daylight Saving, enable/disable (group-1 register 87H)
Set
Command C87,SS
Reply A
Get
Command B87
Reply ASScc
SS- state (00: disabled, 01: enabled), cc- checksum
The Daylight Savings Enable/Disable register is use to enable or disable
Daylight Saving Time function. The default factory setting is 00 (disabled).
Note: when start-date and end-date were set as same date, TR510E will
automatically disable Daylight Saving Time function.
Door unlock duration (group-1 register 88H)
Set
Command C88,DD
Reply A
Get
Command B88
Reply ADDcc
DD- Door unlock duration in seconds, in Hex format (00H-FFH), cc-
checksum
TR510E User's Manual
34
Possible error codes:04, 07
Possible error codes: 04, 07
Possible error codes: 04, 07
Possible error codes: 04, 07