Promag TR510E Manual page 4

Ethernet arrangement is simple: just plug the Ethernet cable (use supplied or
your own cables) into the TR510E's RJ45 connector and connect the other side
to the Ethernet port of HUB (see the drawing below).
TR510E's interface connector pin assignment can be found in Appendix B.
Understanding machine numbers
For single-terminal Ethernet communications, you needn't specify your
TR510E's machine number let it be the default number (#00) is our suggestion.
For multi-terminal Ethernet communications and for your easy to identify,
you sure have all Terminals on the network have unique machines numbers,
even machine number is not a network address that uniquely identifies the
Terminal on the network. Each TR510E must be assigned a unique IP address.
It is a common convention to write the IP address in a so-called "dot notation",
i.e. "192.168.100.215". Consult with your Network Administrator to determine
the suitable IP address for each TR510E you are planning to install on the
network. Note, the matching IP address must also be set in the PC software
you are using to control the TR510E. For your easily setting the IP address
and others setting about network, we supply a set up software called DS
manager (Device Server manager). For detail please see the section-
"Appendix E. Installation".
Having two different Terminals on the network set up to the same machine
number will result in the inability to communicate with both Terminals.
Machine number can be in the 0 to 255 range (00-FF Hex). 0 is a universal
machine number- any Terminal responds to it regardless of this Terminal's
actual machine number setting. Machine number of 0 can be used for Ethernet
communications- you only have a single Terminal in this case, so you can
TR510E User's Manual
4