Table of Contents
Advertisement
Spectral ZP-5
seconds.
11) When the display shows FADE, press the ENTER button to open the menu and press the UP/DOWN
buttons to set the fade time between particular scenes. The adjustment range is between 0-255,
from 0 to 255 seconds.
7.1. How to make your own custom program
01) First, start with PR.01 and add the desired settings in scene 1 (SC.01), then scene 2 (SC.02) , etc.
02) In this way you can add a maximum of 30 scenes.
03) After that, you can start with PR.02 and create a maximum of 30 scenes again.
04) You can repeat these steps, until you've reached PR.10, step 30.
05) It is possible to create 300 separate scenes.
8. Settings
With this menu you can set the device's settings.
01) In the main menu, press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Now you will need to insert the password to access the menu.
04) Press the buttons in the following order: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
05) Press the UP/DOWN buttons to toggle between the menus described below.
8.1. Password
With this menu you can set whether the display becomes locked after remaining idle for 30 seconds.
01) When the display shows
02) Press the UP/DOWN buttons to choose between ON and OFF.
03) If you have selected ON, press the ENTER button to confirm.
04) It will now take 30 seconds for the device to become locked.
05) If this options remains active, the device will always ask for the password on start up.
06) In order to unlock the device, press the buttons in the following order: UP>DOWN>UP>DOWN and
press the ENTER button to confirm.
8.2. Upload
With this menu, you can export current programs from the master device to the connected slave
devices.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The display will show
05) While exporting, the devices will light up yellow.
06) If there are any problems with exporting, the master and the slave devices will light up red.
07) If the operation was completed successfully, the master and the slave devices will light up green.
08) If the operation was completed successfully, the display will show OK.
8.3. Reset
With this menu, you can reset the custom programs.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The custom programs will now be reset.
Ordercode: 43539
, press the ENTER button to open the menu.
.
18
.
.
.
Advertisement
Table of Contents
