Multiple Spectrals (Dmx Control) - SHOWTEC Spectral ZP-5 Manual

Spectral ZP-5

Multiple Spectrals (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Spectrals and other devices.
04) Link the units as shown in fig. 04. Connect a light controller to the first unit's "in" 3-pin DMX IP65 cable,
using a DMX cable. Connect the first unit's "out" 3-pin DMX IP65 cable with the second unit's "in" 3-
pin DMX IP65 cable. Link the second, third, and fourth units.
05) Always use IP65 XLR extension cables to connect the devices, in order to keep them waterproof.
06) Supply electric power: Plug electric mains power cords into each unit's PowerCON True power IN
socket, then plug the other end of the mains power cord into proper electric power supply sockets,
starting with the first unit. Do not supply power before the whole system is set up and connected
properly.
Multiple Spectrals DMX Set Up
Ordercode: 43539
Note : Link all cables before connecting electric power
11
Fig. 04