Table of Contents
Advertisement
Polar 340 WashFX IP65 Moving Head
Base Plate
13) 4 x mounting holes for the quick-lock brackets
14) M12 GORE
valve
®
15) Safety eye
Installation
Remove all packing materials from the Polar 340 WashFX Moving Head. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110 V specification product on 240 V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 5 modes:
One Polar (Auto Program, Custom Programs)
01) Fasten the effect light to a firm trussing or mount it on flat surface. Leave at least 1,3 m on all sides
for air circulation.
02) Secure the device with a safety cable (order code 70454 / 70456).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Polar is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see 3. Run Mode on page 27 for more information.
Order code: 40101
●
Stand-alone (Auto program, Custom programs)
●
Manual
●
Master/Slave
●
DMX-512/RDM: HSIC (27 channels), SSP (25 channels), Tour (30 channels),
TR16 (37 channels), Pixel (52 channels), CMY (31 channels)
●
Art-Net/sACN: HSIC (27 channels), SSP (25 channels), Tour (30 channels),
TR16 (37 channels), Pixel (52 channels), CMY (31 channels)
11
Fig. 06
Advertisement
Table of Contents
