Troubleshooting - Icom IC-A24 Instruction Manual

IC-A24-Nocl.qxd 04.9.1 5:50 PM
9

TROUBLESHOOTING

If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
PROBLEM
No power comes on.
No sound comes from
the speaker.
Transmitting impossible. • Some channels are receive only.
The display channel
can not be selected.
Scan does not start.
No beep sounds.
29
Page 30
POSSIBLE CAUSE
• The battery is exhausted.
• Bad connection for the battery pack.
• Squelch level is too deep.
• Volume level is too low.
• The battery is exhausted.
• Lock function is activated.
• All memory channels are not programmed • Set the "TAG" settings of desired
programmed as "TAG" channels.
• Beep tones turned OFF.
SOLUTION
• Recharge the battery pack.
• Check the connection to the transceiver. 25–27
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
• Change channels.
• Recharge the battery pack.
• Push , then push [7• ].
channels.
• Push , then push [8• ] to adjust
BEEP
the beep tone level
REF.
pgs. 7,
pgs. 8, 9
p. 8
p. 25–27
p. 11
p. 17
p. 11