Table of Contents
Advertisement
damage to the system by reversed wiring of ground and power lines. Refer to Appen-
dix A.3.
2.5
USB Connector
The USB interface supports Plug and Play, which enables you to connect or discon-
nect a device whenever you want, without turning off the computer. The UNO-1372G-
J provides four USB connectors, which gives complete Plug & Play and hot swapping
feature. For the UNO-1372G-J, there are four USB ports which complies with USB
EHCI, Rev. 3.0. Refer to Appendix A.5 for pin assignments.
2.6
RTC Battery Specification
The UNO-1372G-J has an RTC Battery to ensure the setting in BIOS and system
clock can be kept, even with power disconnected for a short time.
Type: BR2032
Output Voltage: 3 V
2.7
Power Button/Power Management
The default setting of UNO-1372G-J is AT mode. UNO-1372G-J will be automatically
turned on while there is power input. The "PWR" button can power off the system.
UNO-1372G-J is also able to be switched to ATX mode for powering on and off via
BIOS (Refer to Appendix A.8).
2.8
Reset Button
Press the "Reset" button to activate the hardware reset function.
2.9
PCI Express Mini Card Socket
The UNO-1372G-J supports
(MINI1) interface is mainly targeted at supporting iDoor technology/modules for
diverse applications such as isolated COM port, Profibus, WLAN GPRS, 3G, mRAM
and iDoor Module. Users can install the card easily using the optional kit. MINI2 inter-
face is mPCIe signal co-lay mSATA signal. It will automatically detected the devices
you installed and define to go with mPCIe or mSATA signal.
Note!
There is a Micro SIM card slot besides mini PCIe(MINI1) for supporting
3G/LTE function. You still require a 3G/LTE Mini-PCIe module installed
to be able to use the function.
UNO-1372G-J User Manual
DC
two full size socket for PCI Express mini cards
8
.The
Advertisement
Table of Contents
