18
Volume Calculations
18.1
The Volume Calculations Menu
The menu
Volume Calculations
•
This menu lists all of the necessary steps and the option to close the program.
Menu Option
Step 1)
Survey Points
Step 2)
Triangulate Surface
Step 3)
Compute Volume
Step 4)
End Volume Calculations
Next step
IF
to start the program
to configure the program
to close the program
TPS1200+/TS30/TM30
CONT (F1)
To select the highlighted option and
to continue with the subsequent
screen.
SHIFT CONF (F2)
To configure the program.
Description
To measure points defining a new surface or
extending existing surfaces currently stored in the
active job.
To triangulate (delauny triangulation) the measured
surface points to establish the surface.
To compute the volume of a surface by a reference
(3D point, entered elevation) or by the stockpile
method.
To end Volume Calculations and return to the screen
from where Volume Calculations was accessed.
THEN
highlight the relevant option and press CONT (F1).
press SHIFT CONF (F2).
highlight End Volume Calculations, press CONT
(F1).
245