Saving Changes Or Resetting Factory Defaults; Rebooting The Netguardian - DPS Telecom NetGuardian 216T User Manual

37
2.17

Saving Changes or Resetting Factory Defaults

Your NetGuardian 216T comes equipped with Non Volatile RAM (NVRAM), which enables the retention of
data in the event of power loss. This section allows you to write and initialize the NVRAM.
Note: Some changes require a reboot of the NetGuardian to take effect (see Section 2.18, "Rebooting the
NetGuardian)."
1. From the Edit menu select NVRAM (see Figure 2.17.1).
2. Select Write to cause the current data in RAM to be written to NVRAM and then verified.
3. Select Initialize to reload factory defaults into NVRAM.
DO NOT SELECT THIS OPTION UNLESS YOU WANT TO RE-ENTER ALL OF YOUR
4. The "Purge BAC" option is not used for NetGuardian 216T.
Fig. 2.17.1. NVRAM enables the NetGuardian to retain data even through a power loss
2.18

Rebooting the NetGuardian

Click on the Reboot link from the Edit menu to reboot the NetGuardian after writing all changes to NVRAM.
Any changes to port settings require a reboot to take effect. The window footer will display the text Reboot
Needed if a reboot is necessary to initiate changes.
CONFIGURATION INFORMATION AGAIN.