Setting The System Date And Time - DPS Telecom NetGuardian 216T User Manual

35
12. Set the Web Monitor Refresh time between 5 and 120 seconds. This timer enables the user to specify
how long the NetGuardian should wait before auto-refreshing a Monitor page to the Web browser. The
default Web monitor refresh time is 60 seconds.
Note: The time units are preset to seconds by default and cannot be changed.
13. Set the LMI Poll Delay time between 5 and 120 seconds. It determines how often the RTU communicates
with the far-end T1 WAN device to verify WAN connectivity.
2.15

Setting the System Date and Time

Fig. 2.15.1. The current date and time can be entered from the Date and Time screen or from an SNMP manager
The date is entered in the mm/dd/yyyy format and the time is entered in the hh:mm:ss format.
!
Hot Tip!
The date and time can also be set from an SNMP manager.
Use the following steps to manually set the system's time and date:
1. From the Edit menu, select Date and Time (see Figure 2.15.1).
2. Enter the appropriate date, the day of the week, and time.
3. Click Submit Data to save the data and time settings.
Note: The date and time will need resetting following a power failure or reboot unless your NetGuardian is
equipped with the real-time clock option or network time is enabled (see Section 2.15.1 for instructions on
setting the network time configuration).